Heater Blower Resistor; Heater Control Lever Assembly - Suzuki Jimny Service Manual

Heater Blower Resistor

REMOVAL
1) Disconnect negative (–) cable at battery.
2) Disable air bag system, if equipped.
Refer to "Disabling Air Bag System" in Section 10B.
3) Disconnect resistor coupler.
4) Remove blower motor resistor (3) as shown figure.
1. Heater unit
2. Blower motor
INSPECTION
Measure each terminal-to-terminal resistance on resistor
If measured resistance is incorrect, replace heater blower motor
resistor.
Heater blower resistor resistance
Me-Lo: approx. 2.4 Ω
Me-Hi: approx. 1.2 Ω
INSTALLATION
1) Reverse removal procedure for installation.
2) Enable air bag system, if equipped.
Refer to "Enabling Air Bag System" in Section 10B.

Heater Control Lever Assembly

REMOVAL
1) Disconnect negative (–) cable at battery.
2) Disable air bag system, if equipped.
Refer to "Disabling Air Bag System" in Section 10B.
3) Remove meter cluster hood, ashtray, center garnish, instru-
ment glove box and radio or accessory case (if equipped),
Then remove mounting screws (2) from heater control lever
assembly (1).
HEATER AND VENTILATION 1A-5