Valve Lash; Engine Oil And Filter - Suzuki Jimny Service Manual

0B-6 MAINTENANCE AND LUBRICATION
3) Check belt for tension.
Power steering pump and/or A/C compressor drive belt
tension
"a": 6 – 9 mm (0.24 – 0.35 in.) deflection under 100 N
(10 kg, 22 lb) pressure.
4) If belt tension is out of above specification, adjust it referring
to "Compressor Drive Belt" in Section 1B or "Power Steering
Belt Check" in Section 3B1.
1. P/S pump pulley
2. Camshaft pulley
3. A/C compressor pulley (if equipped)
4. Belt tension pulley
5) Connect negative cable to battery.
REPLACEMENT
Replace belt with new one referring to "Compressor Drive Belt" in
Section 1B or "Power Steering Belt Check" in Section 3B1.

Valve Lash

INSPECTION
1) Inspect intake and exhaust valve lash and adjust as neces-
sary.
Refer to "Valve Lash (Clearance)" in Section 6A1 for valve
lash inspection and adjustment procedure.
1. Camshaft
2. Thickness gauge

Engine Oil and Filter

CHANGE
WARNING:
• New and used engine oil can be hazardous.
Be sure to read "WARNING" in General Precaution in
Section 0A and observe what in written there.
• Step 1) – 7) outlined below must be performed with
ENGINE NOT RUNNING. For step 8), be sure to have
adequate ventilation while engine is running.
Before draining engine oil, check engine for oil leakage. If any evi-
dence of leakage is found, make sure to correct defective part
before proceeding to the following work.