5E-38 ANTILOCK BRAKE SYSTEM (ABS)
Rear Wheel Sensor Ring
REMOVAL
1) Remove rear axle shaft. Refer to "Rear Axle Shaft and
Wheel Bearing" in Section 3E.
2) In order to remove sensor ring (3) from retainer ring (2),
grind with a grinder one part of the sensor ring (3) as illus-
trated till it becomes thin.
CAUTION:
• Cover vinyl sheet (4) or the like over wheel bearing so
that fine grains from grinding will not enter there.
• Be careful not to go so far as to grind the retainer ring
(2).
1. Rear axle
"A": Grind with grinder
3) Break with a chisel the thin ground sensor ring, and it can be
removed.
INSTALLATION
1) Press-fit sensor ring (1) as shown.
NOTE:
Use care not to cause any damage to outside of retainer
ring.
2) Install rear axle shaft referring to "Rear Axle Shaft and Wheel
Bearing" in Section 3E.
3) Install brake drum and wheel.
Refer to "Brake Drum" in Section 5.