Suzuki Jimny Service Manual page 354

5) Remove rear wheel speed sensor (1) from rear axle housing.
CAUTION:
• Do not pull wire harness when removing rear wheel
speed sensor (1).
• Do not cause damage to surface of rear wheel speed
sensor and do not allow dust, etc. to enter its installa-
tion hole.
2. Rear wheel sensor ring
SENSOR INSPECTION
• Check sensor for damage.
• Check sensor for resistance.
Resistance between terminals of sensor
: 1.4 – 1.8 kΩ at 20 °C (68 °F)
Resistance between sensor terminal and sensor body
: 1 MΩ or more
If any malcondition is found, replace.
SENSOR RING INSPECTION
• Check ring teeth for being missing, damaged or deformed.
• Turn wheel and check if ring rotation is free from eccentricity
and looseness.
• Check that no foreign material is attached.
If any faulty is found, repair or replace.
INSTALLATION
1) Check that no foreign material is attached to sensor and ring.
2) Install it by reversing removal procedure.
Tightening torque
Rear wheel speed sensor bolt and rear wheel speed sen-
sor harness clamp bolts
(a) : 10 N·m (1.0 kg-m, 7.2 lb-ft)
CAUTION:
Do not pull wire harness or twist more than necessary
when installing rear wheel speed sensor.
1. Sensor bolt
2. Clamp bolt
3) Check that there is no clearance between sensor and rear
axle housing.
ANTILOCK BRAKE SYSTEM (ABS) 5E-37