Crankshaft position sensor
INSPECTION
Check crankshaft position sensor referring to step 2 and 6 of
"DTC P0335 (No.23) Flow Table" in Section 6. If malfunction is
found, replace.
REMOVAL
1) Disconnect negative cable at battery.
2) Remove generator drive belt, loosen pivot bolt and move
generator outward.
3) Disconnect connector from crankshaft position sensor.
4) Remove crankshaft position sensor (1) from cylinder block.
INSTALLATION
1) Check to make sure that crankshaft position sensor and pul-
ley tooth is free from any metal particles and damage.
2) Install crankshaft position sensor to cylinder block.
3) Connect connector to it securely.
4) Adjust generator belt tension, refer to "Water Pump Belt Ten-
sion" in Section 6B.
5) Connect negative cable to battery.
ENGINE AND EMISSION CONTROL SYSTEM 6E-35