Suzuki Jimny Service Manual page 227

3E-8 REAR SUSPENSION
INSTALLATION
1) Install spring rubber seat (1).
NOTE:
Before installing spring rubber seat (1), apply soap water
on it.
2) Install coil spring (2) on spring seat (1) of axle housing and
then raise axle housing.
NOTE:
• Upper and lower diameters of coil spring (2) are differ-
ent.
Bring larger diameter end at bottom and set its open
end in place on spring seat (1).
• When seating coil spring (2), mate spring end with
stepped part (3) of rear axle spring seat (1) as shown.
A : Upper side (small dia.)
B : Lower side (large dia.)
3) Install shock absorber lower mounting bolt.
Tighten bolt temporarily by hand.
4) Install brake flexible hose E-ring.
5) Install wheel and tighten wheel nuts to specified torque.
Tightening torque
Wheel nuts
(a) : 95 N·m (9.5 kg-m, 69.0 lb-ft)
6) Lower hoist and tighten absorber lower bolt (2) to specified
torque.
Tightening torque
Shock absorber lower bolt
(a) : 85 N·m (8.5 kg-m, 61.5 lb-ft)
NOTE:
For tightening of lower bolt (2), refer to NOTE given under
"Shock Absorber" in this section.