Main Bearings, Crankshaft and Cylinder Block
Tightening torque
Do not reuse.
Apply engine oil to inside / sliding
surface.
"a" : 3 mm (0.12 in.)
"b" : 2 mm (0.08 in.)
1. CKP sensor (if equipped)
2. Knock sensor
3. Cylinder block
4. Venturi plug
5. Main bearing
6. Sensor plate
7. Crankshaft timing sprocket key
8. Crankshaft
9. Thrust bearing
10. Rear oil seal housing
: Apply specified amount [A] of seal-
ant 99000-31150 to mating surface.
11. Rear oil seal
ENGINE MECHANICAL (M13 ENGINE) 6A1-79
12. Input shaft bearing
13. Flywheel
14. Main bearing cap
15. Flywheel mounting bolt
: Apply sealant 99000-31110 to thread
part.
16. Rear oil seal housing mounting bolt
17. Main bearing cap No.2 bolt
18. Main bearing cap No.1 bolt
1) Tighten all bolts to 50 N·m (5.0 kg-m)
2) Then, turn all bolts to 60°