Power Steering (P/S) Gear Box - Suzuki Jimny Service Manual

3B1-18 POWER STEERING (P/S) SYSTEM (If equipped)
INSTALLATION
CAUTION:
After installation, fill A/T fluid (an equivalent to
®
DEXRON -II, DEXRON
to bleed air referring to "Air Bleeding Procedure" in this
section.
Install components in reverse order of removal procedure noting
the following points.
• Tighten each bolt as specified below.
Tightening torque
Oil pump mounting bolts
(a) : 25 N·m (2.5 kg-m, 18.5 lb-ft)
Oil pump high pressure union bolt
(b) : 60 N·m (6.0 kg-m, 43.5 lb-ft)
1. Union bolt
• Adjust P/S belt referring to "Power Steering Belt Check" in
this section.
• Connect pressure switch terminal.

Power Steering (P/S) Gear Box

REMOVAL
1) Take out fluid in P/S fluid reservoir with syringe or such.
2) Turn steering wheel fully counterclockwise and loosen sector
shaft nut of P/S gear box.
3) Return steering wheel to straightforward state and remove
pitman arm from P/S gear box by using puller.
4) Remove radiator (for left-steering vehicle) referring to "Radi-
ator" in Section 6B
5) Remove radiator support member.
6) Disconnect suction hose and return hose from P/S fluid res-
ervoir, and remove P/S fluid reservoir assembly (for left-
steering vehicle).
7) Remove steering lower shaft joint bolt (2).
1. Steering lower shaft
® ®
-IIE or DEXRON -III) and be sure