Fluid Pressure Test (If Equipped With Lspv) - Suzuki Jimny Service Manual

Fluid Pressure Test (If Equipped with LSPV)

Test procedure for LSPV assembly is as follows.
Before testing, confirm the following.
• Fuel tank is filled with fuel fully.
• Vehicle is equipped with spare tire, tools, jack and jack han-
dle.
1) Stop vehicle on level floor and place approximately about
140 kg (309 Ibs) weight on rear housing so that rear axle
weights 600 kg (1323 Ib).
Rear axle weight
"L" : 600 kg (1323 lb)
2) Install special tool to front and rear brake.
NOTE:
Special tool should be connected to bleeder plug hole of
front (driver's side brake) and rear brakes.
Special tool
Front brake
(A) : 09956-02310
(B) : 55473-82030 (Use the air bleeder plug supplied as a
spare part)
Rear brake
(A) : 09956-02310
(B) : 55473-82030 (Use the air bleeder plug supplied as a
spare part)
1. Air bleeder plug
2. Weight
3. Attachment
3) Depress brake pedal gradually till fluid pressure of front
brake becomes as specified below and check corresponding
pressure of rear brake. It should be within specification given
below.
Front brake
5000 kPa
2
50 kg/cm
711 psi
As done above, apply 100 kg/cm
check that rear brake pressure is within specification as given
below.
Front brake
10000 kPa
2
100 kg/cm
1422 psi
BRAKES 5-15
Rear brake
3800 – 5100 kPa
2
38 – 51 kg/cm
540 – 725 psi
2
pressure to front brake and
Rear brake
5100 – 6500 kPa
2
51 – 65 kg/cm
725 – 924 psi