Front Wheel Sensor Ring - Suzuki Jimny Service Manual

Front Wheel Sensor Ring

REMOVAL
1) Remove wheel hub with sensor ring. Refer to "Wheel Hub /
Bearing / Oil Seal" in Section 3D.
2) Remove sensor ring (1) from wheel hub (2) as shown.
CAUTION:
Pull out sensor ring (1) from wheel hub (2) gradually and
evenly. Attempt to pull it out partially may cause it to be
deformed.
3. Vise
4. Lever
INSPECTION
• Check ring teeth for being missing, damaged or deformed.
• Check sensor ring (1) for being deformed.
• Check that no foreign material is attached.
If any malcondition is found, repair or replace.
INSTALLATION
1) Install sensor ring (3) as shown.
NOTE:
• Pipe (2) used here should have inner diameter of 90
mm (3.55 in) – 96 mm (3.77 in) and its outside should
not contact teeth of sensor ring.
• Use care not to insert wheel hub diagonally.
1. Steel plate
4. Wheel hub
5. Hydraulic press
2) Install wheel hub, brake disc, brake caliper, locking hub and
wheel.
Refer to "Wheel Hub / Bearing / Oil Seal" in Section 3D.
ANTILOCK BRAKE SYSTEM (ABS) 5E-35