Suzuki Jimny Service Manual page 528

5) After applying engine oil to housing bolts, tighten them tem-
porarily first. Then tighten them by the following numerical
order in figure. Tighten a little at a time and evenly among
bolts and repeat tightening sequence two or three times
before they are tightened to specified torque.
Tightening torque
Camshaft housing bolts (a) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
6) Install timing chain with crankshaft sprocket referring to
"Timing Chain and Chain Tensioner" in this section.
7) Install timing chain cover referring to "Timing Chain Cover" in
this section.
8) Check valve lashes referring to "Valve Lash" in this section.
9) Install cylinder head cover and oil pan referring to "Cylinder
Head Cover" and "Oil Pan and Oil Pump Strainer" in this sec-
tion.
10) Install radiator with cooling fan and connect A/T fluid hoses
(vehicle with A/T), radiator inlet and outlet hoses referring to
"Water Pump Belt and Cooling Fan" and "Radiator" in Sec-
tion 6B.
11) Adjust generator belt tension referring to "Water Pump Belt
Tension" in Section 6B.
12) Adjust A/C compressor and/or P/S pump belt tension (if
equipped) referring to "Compressor Drive Belt" in Section 1B
or "Power Steering Belt" in Section 3B1.
13) Refill cooling system with coolant, engine with engine oil and
A/T with specified A/T fluid (vehicle with A/T).
14) Verify that there is no coolant leakage, oil leakage and A/T
fluid leakage (vehicle with A/T) at each connection.
ENGINE MECHANICAL (M13 ENGINE) 6A1-47