Diagnostic Trouble Code (Dtc) Clearance - Suzuki Jimny Service Manual

ENGINE GENERAL INFORMATION AND DIAGNOSIS 6-15
NOTE:
• If abnormality or malfunction lies in two or more areas,
malfunction indicator lamp indicates applicable codes
three times each.
And flashing of these codes is repeated as long as
diagnosis terminal is grounded and ignition switch is
held at ON position.
• Take a note of diagnostic trouble code indicated first.
4) After completing the check, turn the ignition switch OFF posi-
tion and disconnect service wire from monitor coupler.

Diagnostic trouble code (DTC) clearance

[Using SUZUKI Scan Tool]
1) Connect SUZUKI scan tool to data link connector in the
same manner as when making this connection for DTC
check.
2) Turn ignition switch ON.
3) Erase DTC and pending DTC according to instructions dis-
played on scan tool. Refer to scan tool operator's manual for
further details.
4) After completing the clearance, turn ignition switch off and
disconnect scan tool from data link connector.
NOTE:
DTC and freeze frame data stored in ECM memory are
also cleared in following cases. Be careful not to clear
them before keeping their record.
• When power to ECM is cut off (by disconnecting bat-
tery cable, removing fuse or disconnecting ECM con-
nectors)
• When the same malfunction (DTC) is not detected
again during 40 engine warm-up cycles.
[Without Using SUZUKI Scan Tool]
1) Turn the ignition switch OFF position.
2) Disconnect battery negative cable for specified time below to
erase diagnostic trouble code stored in ECM memory and
reconnect it.
Time required to erase DTC
Ambient temperature
Over 0 °C (32 °F)
Under 0 °C (32 °F)
Time to cut power to ECM
30 sec. or longer
Not specifiable.
Select a place with higher than
0 °C (32 °F) temperature.