A/C Switch
REMOVAL AND INSTALLATION
Refer to "Heater Control Lever Assembly" in Section 1A.
INSPECTION
• Press A/C switch button and check if there is continuity
between terminals "A" and "B".
• With battery voltage (+) connected to terminal "C" and (–) to
terminal "A", press A/C Switch button and blower fan switch
to "Hi" (3rd position).
Check if indicator lamp lights.
1. Blower fan and A/C switch
Condenser Cooling Fan Motor Relay
INSPECTION
1) Disconnect negative (–) cable at battery.
2) Remove condenser cooling fan motor relay (1) from vehicle.
3) Check that there is no continuity between terminal "a" and
"b". If there is continuity, replace relay.
4) Check that there is continuity between terminals "a" and "b"
when battery is connected to terminal "c" and "d".
If there is no continuity, replace relay.
Compressor
REMOVAL
1) Run engine at idle speed with air conditioning ON for 10 min-
utes. After that stop the engine.
2) Disconnect negative (–) cable at battery.
3) Recover refrigerant from refrigeration system by referring to
"Recovery" in this section.
NOTE:
The amount of removed compressor oil must be mea-
sured for replenishing compressor oil.
AIR CONDITIONING (OPTIONAL) 1B-39