Auto Logging Function - Mitsubishi Electric MELSEC iQ-R Series User Manual

1.7

Auto Logging Function

The auto logging function automatically starts the data logging function, event logging function, and report function when an
SD memory card to which the auto logging settings are written in advance is inserted in a running high speed data logger
module.
The data logging can be stopped automatically by specifying the time to perform data logging.
Precautions
When using the auto logging function, do not connect the high speed data logger module to LAN.
In addition, do not set to transfer files and e-mails in the data logging setting, the event logging setting, and the report setting.
Procedure to use
The following shows the procedure to use of the auto logging function.
Before executing the auto logging function, set the auto logging setting in Configuration Tool.
Page 144 Logging operation setting
1.
Insert an SD memory card in a personal computer.
2.
Write the auto logging setting to the inserted SD memory card.
Page 129 Exporting module operating file
3.
Remove the SD memory card from the personal computer.
4.
Insert an SD memory card in a high speed data logger module.
The CARD RDY LED of the high speed data logger module turns ON and the auto logging starts.
5.
'File access stop request' (Y2) turns ON when any conditions for stopping a module operation is not set.
The CARD RDY LED of the high speed data logger module turns ON and the auto logging stops.
6.
Remove the SD memory card from the high speed data logger module.
To terminate the auto logging function forcibly, stop a file access by any of the following methods.
• Switch operation on the front of a module
• Input/output (X/Y) signal operation
• Online operation in Configuration Tool
1 FUNCTION
92
1.7 Auto Logging Function
ÔLogging
Factory
Ò Write the auto logging setting to the SD
ÓSend
ÕReturn shipment
memory card
Office
ÖAnalyze logging data