Time Synchronization Setting - Mitsubishi Electric MELSEC iQ-R Series User Manual

*2 Can be omitted if only accessing the same network.
*3 To obtain an IP address from a domain name, the IP address is searched in order from the DNS server specified as a primary DNS
server.
*4 When obtaining an IP address from a domain name, if it cannot be obtained from the primary DNS server, the IP address is searched
from the DNS server specified as a secondary DNS server.
*5 When there is no response from the destination within 5 seconds, retries once. If there is still no response after that, the module error
occurs.
*6 Set the transmission interval considering the load on the network.

Time synchronization setting

Configure the time to be used in a high speed data logger module.
Obtain the time to be used in a high speed data logger module from a CPU module (CPU No. 1 in a multiple CPU system)
then use it.
For details of the time synchronization setting function, refer to the following:
Page 90 Time Synchronization Function
Window
Click "Common setting" on the edit items tree, then click the [Time synchronization setting] button.
Displayed items
Item
Synchronize at fixed intervals
Synchronization timing
setting
2 HIGH SPEED DATA LOGGER MODULE CONFIGURATION TOOL
132
2.4 Common Setting

Fixed cycle
Interval

Fixed time
Time
Day of the week
Description
Select this to synchronize the time of CPU module at the fixed interval.
Select this to synchronize time at the specified time interval (minutes).
Specify the intervals to synchronize the time in minute.
Select this to synchronize time at the specified time.
Select the time (hour, minutes) to synchronize the time.
Select the day of the week for time synchronization.
If no checkboxes are selected, the time synchronization will be applied
everyday.