Mitsubishi Electric MELSEC iQ-R Series User Manual page 287

Error code Error name
3020H Data type setting error
3021H Module error
3022H Data type setting error
3027H to 302AH Module error
302BH to 302DH Data sampling method
specification error
302EH Layout type specification error
302FH to 3036H Module error
3037H Setting file error
3038H Module error
3039H Setting file error
303AH to 3042H Module error
3043H E-mail address setting error
3044H Setting file error
3045H E-mail address setting error
3046H Setting file error
3047H File transfer destination setting
error
Error description
An invalid setting has been made in the data type
setting.
Or the setting file is corrupted.
A module error has been detected.
An invalid setting has been made in the data type
setting.
Or the setting file is corrupted.
A module error has been detected.
An invalid data sampling method has been
specified.
Or the report setting file is corrupted.
An invalid layout type has been specified.
Or the report setting file is corrupted.
A module error has been detected.
There is no setting file.
Or the setting file is corrupted.
A module error has been detected.
There is no setting file.
Or the setting file is corrupted.
A module error has been detected.
The destination specified in the e-mail notification
settings for the "Event logging setting" is not
registered.
Or the setting file is corrupted.
There is no setting file.
Or the setting file is corrupted.
The destination specified with the save setting is
not registered.
Or the setting file is corrupted.
There is no setting file.
Or the setting file is corrupted.
The destination specified with the save setting is
not registered.
Or the setting file is corrupted.
Corrective action
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
• Take measures to reduce noise.
• Reset the CPU module and switch it to RUN. If
the same error is displayed again, a hardware
failure may occur in high speed data logger
module. Please consult your local Mitsubishi
representative.
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
• Take measures to reduce noise.
• Reset the CPU module and switch it to RUN. If
the same error is displayed again, a hardware
failure may occur in high speed data logger
module. Please consult your local Mitsubishi
representative.
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
• Take measures to reduce noise.
• Reset the CPU module and switch it to RUN. If
the same error is displayed again, a hardware
failure may occur in high speed data logger
module. Please consult your local Mitsubishi
representative.
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
• Take measures to reduce noise.
• Reset the CPU module and switch it to RUN. If
the same error is displayed again, a hardware
failure may occur in high speed data logger
module. Please consult your local Mitsubishi
representative.
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
• Take measures to reduce noise.
• Reset the CPU module and switch it to RUN. If
the same error is displayed again, a hardware
failure may occur in high speed data logger
module. Please consult your local Mitsubishi
representative.
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
• Write the settings again with the Configuration
Tool.
• Replace the SD memory card.
4 TROUBLESHOOTING
4.4 Error Code List
4
285