FusionCol8000-C210 In-room Chilled Water Smart
Cooling Product
User Manual
●
●
Procedure
Step 1 Check whether strong electromagnetic interference exists around the E-label
identification board.
●
●
Step 2 Disconnect the main power supply from the smart cooling product.
Step 3 Contact technical support to replace the smart cooling product backplane.
----End
Issue 05 (2022-12-15)
If the information shown in
display module, the smart cooling product can run properly. To remove this
tip, perform
Step
1.
Figure 11-9 Message 1
If the information shown in
the smart cooling product cannot run properly. Perform
Figure 11-10 Message 2
NO TE
In
Figure
2, the ACC V300R021C00SPC020 version is used as an example to describe
the prompt messages on the screen. The version in use may vary.
If yes, contact technical support.
If no, continue with
Step
Copyright © Huawei Digital Power Technologies Co., Ltd.
Figure 11-9
is displayed on the screen of the
Figure 11-10
is displayed on the controller LCD,
2.
11 FAQ
Step 2
to end.
148