Huawei FusionCol8000-C210 User Manual page 105

FusionCol8000-C210 In-room Chilled Water Smart
Cooling Product
User Manual
●
●
●
●
Initial Startup
After factory settings are restored, startup verification is required.
Step 1 Tap Start on the home screen to enter the initial startup screen. Tap OK to enter
the startup authorization screen.
Figure 5-14 Startup authorization
Step 2 Contact technical support engineers and notify them of the barcode and
verification code to obtain the service authorization code.
Step 3 Enter the startup password generated by the app in Authorization code on the
startup authorization screen to start the device.
----End
Issue 05 (2022-12-15)
If the unit is powered on again after a power failure, the unit automatically
restores to the original startup/shutdown state before the power failure.
Hardware ports are reserved on the display module to control the status of
remote dry contacts or remote startup and shutdown signals. The status of
remote dry contacts and remote startup and shutdown signals is started by
default.
A unit can be started over the screen or NMS only when the status of remote
dry contacts or remote start/shutdown signal is Start.
If you choose Settings > System Settings > System Control and set
Password required for start or shutdown onsite to Yes, a password is
required for startup or shutdown. If you set Password required for start or
shutdown onsite to No, no password is required for startup or shutdown.
NO TICE
NO TE
The QR code shown in the preceding figure is used for scanning on the mobile app.
NO TE
Technical support engineers can obtain the service authorization code through the app. For
Data Center Facility Deployment Guide .
details, see the
Copyright © Huawei Digital Power Technologies Co., Ltd.
5 Power-On Commissioning
97