ABB i-bus KNX Product Manual page 9

ABB i-bus® KNX SAFETY
2 Safety
2.1 General safety instructions
Protect the device from moisture, dirt and damage during transport, storage and operation.
►
Operate the device only in a closed housing (distribution board).
►
Operate the device only within the specified technical data.
►
Mounting, installation, commissioning and maintenance must be carried out only by qualified electri-
►
cians. (old)
Disconnect device from the supply of electrical power before mounting.
►
2.2 Proper use
The Switch/Shutter Actuators are intended to be used to activate 230 V AC shutter and blind drives and
to switch primarily ohmic electrical loads in a KNX environment.
NOTICE
The outputs on the device are not interlocked mechanically. The connection of shutter/blind motors to
Switch Actuator outputs will result in damage to the shutter/blind motor.
►
►
Connect shutter/blind motors only to Shutter Actuator output pairs.
Do not drop below the switching/reversing time for the shutter/blind motor connected.
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 9