ABB i-bus® KNX PARAMETERS
—
7.10.6.1.4
DEPENDENT PARAMETER
Number of flashing cycles
This parameter can be used to set the number of On/Off changes.
Options
0 ... 5 ... 100
Condition for visibility:
Parameter window Flashing \ Parameter Parameter setting \ Option Individual
—
7.10.6.1.5
DEPENDENT PARAMETER
Contact position after flashing
This parameter can be used to define the switching position the relay assumes after flashing.
Options
OFF
ON
Refreshed KNX state
Condition for visibility:
Parameter window Flashing \ Parameter Parameter setting \ Option Individual
The relay switching position is Off.
The relay switching position is On.
The refreshed KNX state is used. More information → Refreshed KNX state, Page 83.
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 212