ABB i-bus KNX Product Manual page 109

ABB i-bus® KNX PARAMETERS
7.3.4 Enable group object "Request status values"
All status messages of the device can be requested with the group object Request status values .
In order to send the status values, one of the following options must be defined for the sending behavior
of the status group objects:
• On request
• After change or on request
Enabling of status group objects and further information:
• → Feedback of switching state via group object "Status switch", Page 194
• → Enable group object "Status information", Page 183
• → Parameter window Status messages, Page 178
Options
No
Yes
7.3.5 Enable central Switch group object
This parameter can be used to enable the central Switch group object Switch . All assigned outputs can
be activated together with the central Switch group object.
Observe the maximum number of switching cycles per minute when using the central switching group
object → Technical data.
Options
No
Yes
7.3.6 Enable central Shutter group objects
This parameter can be used to enable the central Shutter group objects:
• Move blind/shutter Up-Down
• Slat adjustment/stop Up-Down
• Move to position height
• Move to position slat
All assigned outputs can be activated together with the central Shutter group objects.
Observe the maximum number of switching cycles per minute when using the central shutter group ob-
jects → Technical data.
Options
No
Yes
The group object is not enabled.
The group object is enabled.
The group object is not enabled.
The group object is enabled.
The group objects will not be enabled.
The group objects will be enabled.
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 109