ABB i-bus KNX Product Manual page 149

ABB i-bus® KNX PARAMETERS
—
7.9.4.1.3.2
DEPENDENT PARAMETER
Total duration for slat turning from 0 % - 100 %
The total duration for slat turning can be defined with this parameter.
Options
50 ... 1,500 ... 60,000 ms
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual \ Parameter Deter-
mine slat adjustment time \ Option Via total duration for slat turning
—
7.9.4.1.4
DEPENDENT PARAMETER
Number of slat adjustments (from 0 % = open to 100 % = closed)
This parameter can be used to define the number of slat adjustments required to move the slats from
fully closed to fully open.
This parameter is available only in Operating mode Blind/shutter control with slat adjustment .
Options
1 ... 7 ... 60
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual
—
7.9.4.1.5
DEPENDENT PARAMETER
Limit step commands to number of slat adjustments
This parameter can be used to define whether Step commands are limited to the set number of slat ad-
justments.
This parameter is available only in Operating mode Blind/shutter control with slat adjustment .
Options
No
Yes
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual
Note
Note
The number of slat adjustments (steps) is not limited to the value in the parameter Number of slat
adjustments (from 0 % = open to 100 % = closed).
The number of slat adjustments (steps) is limited to the value in the parameter Number of slat ad-
justments (from 0 % = open to 100 % = closed).
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 149