ABB i-bus KNX Product Manual page 150

ABB i-bus® KNX PARAMETERS
—
7.9.4.1.6
DEPENDENT PARAMETER
Total turning of slats after downward movement
This parameter can be used to release slats that became stuck during a movement. This function is re-
quired mainly for slats between the panes of a window.
This parameter is available only in Operating mode Blind/shutter control with slat adjustment .
Options
No
Yes
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual
—
7.9.4.1.7
DEPENDENT PARAMETER
Slat position after reaching lower end position (100 % = disabled)
The slats are normally closed when the blind/shutter reaches the lower end position. This parameter can
be used to define the slat position that the blind/shutter is to assume after reaching the lower end posi-
tion.
• 100 %: The slats are closed
• 1 ... 99 %: The slats will be moved to the corresponding intermediate position
• 0 %: The slats are fully open
This parameter is available only in Operating mode Blind/shutter control with slat adjustment .
Options
0 ... 100 %
Condition for visibility:
Parameter window Blind/Shutter \ Parameter Parameter setting \ Option Individual
Note
The slats are not adjusted after a downward movement.
The slats are fully adjusted once (closed – open – closed) after a downward movement. The slats are
not adjusted if a downward movement is interrupted by a stop command.
Note
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 150