ABB i-bus KNX Product Manual page 10

ABB i-bus® KNX PRODUCT OVERVIEW
3 Product overview
3.1 Device description
The Switch/Shutter Actuators are modular installation devices in pro M design. The devices are designed
for installation in electrical distribution boards and small housings for rapid mounting on a 35 mm
mounting rail (according to EN 60715).
The devices possess mutually independent switching relays with which the following functions can be
implemented:
• Switching electric consumers (individually)
• Activation of 230 V AC blind and shutter drives (in pairs)
The devices do not possess any mutually electromechanically interlocked output contacts.
The devices are provided with bus voltage via the ABB i-bus® KNX. The connection to the ABB i-bus® KNX
is implemented using the bus connection terminal. The consumers are connected at the outputs using
screw terminals (terminal designation on the housing).
3.1.1 Membrane keypad
The devices can be operated manually using the membrane keypad. The membranes on the devices dif-
fer only in the number of zone LEDs.
Complete overview of operating and display elements → corresponding sub-chapter of the individual
product variant.
The safety functions (weather alarms as well as the functions Safety priority , Forced operation and
Disable ) take priority over Manual operation mode. An output cannot be operated using the membrane
keypad if it is disabled by a safety function. If the safety function is canceled in Manual operation
mode, the output reacts corresponding to its parameterization.
3.1.2 Product name description
Abbreviation
S
A
H
/S
x.
x.
x.
x
Tab. 2: Product name description
Note
Description
Switch
Actuator
Hybrid
MDRC
8 = 8-fold
16 = 16-fold
24 = 24-fold
6 = 6 A
10 = 10 A
16 = 16 A
7 = Combined function (Switch/Shutter)
x = Version number (x = 1, 2, etc.)
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 10