Integration Into The I-Bus® Tool; Special Operating States; Reaction On Bus Voltage Failure/Recovery, Download And Ets Reset - ABB i-bus KNX Product Manual
Switch/shutter actuator
Hide thumbs
Also See for i-bus KNX:
- Product manual (264 pages) ,
- Product manual (49 pages) ,
- Product manual (152 pages)
Table of Contents
Advertisement
ABB i-bus® KNX FUNCTION
Function
Switch
Shutter
Tab. 34: Functions of the outputs
4.5
Integration into the i-bus® Tool
The device possesses an interface to the i-bus® Tool.
The i-bus® Tool can be used to read the device data and test the functions. In addition, values can be
simulated for test purposes. If there is no connection between the device and i-bus® Tool, the values will
be simulated but will not be output on the ABB i‑bus®.
The device's physical inputs and outputs can be tested via the i-bus® Tool.
The i-bus® Tool can be downloaded for free from our website (www.abb.com/knx).
A description of the functions is provided in the i-bus® Tool online help.
The interface to i-bus® Tool is not available for Application V1.0. It will be implemented with the next
version.
4.6
Special operating states
4.6.1
Reaction on bus voltage failure/recovery, download and ETS reset
The device's reaction on bus voltage failure, after bus voltage recovery, after ETS download and ETS re-
set can be set in the device parameters.
4.6.1.1
Bus voltage failure
Bus voltage failure describes the failure of the bus voltage, e.g. due to a power failure.
The reaction of the Switch Actuator outputs can be defined in the Parameter window Basic settings, in
the parameter Reaction on bus voltage failure.
The reaction of the Shutter Actuator output pairs can be defined in the Parameter window Basic set-
tings, in the parameter Reaction on bus voltage failure.
4.6.1.2
Bus voltage recovery
Bus voltage recovery is the state that exists after bus voltage is restored. The device will restart after
bus voltage recovery.
The time set in the parameter Sending and switching delay after bus voltage recovery elapses before the
device performs an action.
The reaction of the Switch Actuator outputs can be defined in the Parameter window Basic settings, in
the parameter Reaction after bus voltage recovery.
The reaction of the Shutter Actuator output pairs can be defined in the Parameter window Basic set-
tings, in the parameter Reaction after bus voltage recovery.
A
B
C
D
E
x
x
x
x
x
x
x
x
Note
F
G
H
I
J
K
L
x
x
x
x
x
x
x
x
x
x
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 97
M
N
O
P
Q
R
S
x
x
x
x
x
x
x
x
x
x
x
T
U
V
W
X
x
x
x
x
x
x
x
Advertisement
Table of Contents
