Details Of Input Signals (Simple Motion Module Cpu Module) - Mitsubishi Electric MELSEC-Q Series User Manual

Important
[Y2 to YF] and [X2 to XE] are used by the system, and cannot be used by the user.
If these devices are used, the operation of the Simple Motion module will not be guaranteed.
3.4.2 Details of input signals (Simple Motion module
The ON/OFF timing and conditions of the input signals are shown below.
Refer to the "MELSEC-Q QD77GF Simple Motion Module User's Manual (Positioning
Control)" for signals not listed in the table below.
Device No.
XF Module READY
Signal name
OFF:
Module operation
disabled
ON:
Module operation
enabled
CPU module)
• The signal to confirm the module operation ready status.
• After the power is turned from OFF to ON, this signal turns from
OFF to ON when the module is normal. If the module is in error,
this signal turns from ON to OFF.
[Normal]
PLC READY signal [Y0]
READY signal [X0]
Module READY [XF]
Power supply ON
[Error]
PLC READY signal [Y0]
READY signal [X0]
Module READY [XF]
Power supply ON
3 - 6
Chapter 3 SPECIFICATIONS
Details
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF