Mitsubishi Electric MELSEC-Q Series User Manual page 192

3) Open the network configuration setting window and set parameters as follows.
Project window
[Ethernet/CC IE/MELSECNET]
4) Open the refresh parameter window and set parameters as follows.
Project window
[Ethernet/CC IE/MELSECNET]
5) Write the parameters to the CPU module on the master station. Then reset the
CPU module or turn off and on the power.
[Online] [Write to PLC]
RESET
or Power OFF
POINT
In this example, default values were used for parameters that are not shown above.
For parameter setting, refer to the following. (Refer to Chapter 7.)
[Parameter] [Network Parameter]
[CC IE Field Configuration Setting] button
[Parameter] [Network Parameter]
[Refresh Parameters] button
ON
11 - 6
Chapter 11 PROGRAMMING