Mitsubishi Electric MELSEC-Q Series User Manual page 71

Item
Assign RX/RY points to the station No.17 to 120.
(Refer to Section 8.3.1.)
Points can be assigned in increments of 16 (Start:
RX/RY Setting
To assign points equally or the same points, go to
[Equal Assignment] or [Identical Point Assignment]
under [CC IE Field Configuration]. (Refer to Section
7.4 (1) (d).)
Assign RWw/RWr points to the station No.17 to 120
in increments of 4. (Refer to Section 8.3.1.)
To assign points equally or the same points, go to
RWw/RWr Setting
[Equal Assignment] or [Identical Point Assignment]
under [CC IE Field Configuration]. (Refer to Section
7.4 (1) (d).)
Link refresh target devices in the CPU module are
displayed for each link device of the Simple Motion
Refresh Device module.
Target devices are displayed when refresh
parameters have been set. (Refer to Section 7.6.)
(Note-1): The range from the station No.1 to 4 is valid in the 4-axis module, and the range from the station No.1 to 8 is valid in the 8-axis
module.
Description
0H, End: FH).
Chapter 7 PARAMETER SETTING
Setting range
• Points:
Intelligent Device Station: 16 to 2048
Remote Device Station: 16 to 128
Remote I/O Station: 16 to 64
• Device number: 0 to 1FFFH
(Default: varies depending on the set
module)
• Points:
Intelligent Device Station: 4 to 1024
Remote Device Station: 4 to 64
Remote I/O Station: Cannot be set.
• Device number: 0 to 3FFH
(Default: varies depending on the set
module)
7 - 11
Remark
•If the value
outside the
setting range is
set, one of the
"Parameter error
(error code:
D615H to
D618H)" will
occur.
•Assigning RX/RY
points to the
station No.1 to
(Note-1)
16
invalid. (If the
value within the
setting range is
set, an error will
not occur.)
•If the value
outside the
setting range is
set, one of the
"Parameter error
(error code:
D611H to
D614H)" will
occur.
•Assigning
RWw/RWr points
to the station
No.1 to 16
1)
are all invalid.
(If the value
within the setting
range is set, an
error will not
occur.)
–
are all
(Note-
–