Cc-Link Ie Field Network Configuration; Single Network System - Mitsubishi Electric MELSEC-Q Series User Manual

5.1 CC-Link IE Field Network Configuration

This section describes CC-Link IE Field Network configurations.

5.1.1 Single network system

(1) Overall system configuration
A single network system is a system in which a Simple Motion module (master station)
and slave stations are connected using Ethernet cables as shown below. The Simple
Motion module can be connected with servo amplifiers and slave stations excluding
servo amplifiers. (Up to 120 slave stations and one master station can be connected.)
Also, the devices which the synchronous communication function is
supported/unsupported can be coexisted.
Ethernet cable
(1000BASE-T)
Master station
1 station
Set the station No. as shown below depending on the connected device to the Simple
Motion module.
Station No.
(Note-1)
1 to 16
17 to 120
(Note-1): The range from the station No.1 to 4 is valid in the 4-axis module, and the range from the station
No.1 to 8 is valid in the 8-axis module.
Switching hub
Slave station
Up to 120 stations
Servo amplifier
Slave station excluding a servo amplifier
5 - 2
Chapter 5 SYSTEM CONFIGURATION
Connected device