Setup - Adout (Output Setup For A/D-Input Signal) - Yamaha A3000 Owner's Manual

SETUP Function

SETUP - ADOut (Output Setup for A/D-Input Signal)

Selects the output destinations for the A/D-in signal, and sets the output levels.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Knob 3
Chapter 4 PLAY Mode
134
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
This page sets the main and assignable output destinations and levels for the A/D-in
signal.
Change Page
• Turn the knob to change to a different page within the SETUP function. Available
pages are: PgmMstr, Portmnt, ADSetup, and ADOut (this page).
• Push the knob to move to the Program/Sample Selection screen. ( 95)
MainOut
Selects the main output destination for the A/D-input signal. Available settings are as
follows.
off
Stereo
Effect1,...,Effect3
Level
Sets the output level at the main output.
CONTROL
MIDI / CTRL
Turn Knob 1 to select ADOut.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= off, Stereo, Effect1, Effect2, Effect3
The signal does not flow to any main output. Use this setting
when you want to output the signal through assignable outputs
only (see below).
Output the signal directly to the stereo outputs, bypassing all
effects.
Pass the signal through the selected effect block (Effect 1, Effect
2, or Effect 3), and output the result to the stereo outputs.
= 0,...,127
Knob 4 Knob 5
- -
Select P/S