Program & Sample Selection Screen - Yamaha A3000 Owner's Manual

Program & Sample Selection Screen
The A3000 includes a special selection screen that you can access at almost any time by pushing
Knob 1. You can then use the screen to select a sample or program for playback or editing, and to
set a number of other features as described below. This screen is unlike other screens in that you
can select it regardless of the current mode or function.
PROGRAM/SAMPLE Selection Screen
Use this screen to select a program or sample for playback or editing, or to switch "sample solo" or "MIDI to
sample" features ON or OFF.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT
REC RECORD SETUP
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Important
You cannot access this screen while the COMMAND key is engaged (while the key's
indicator lamp is on), since Knob 1 is assigned a different operation in this cases. Be
sure to release the COMMAND key before trying to select a sample or program.
FYI
This special screen is provided as a convenience, since program and sample selection is
such a frequent operation. The parameters that you set here are the same as (are linked
to) the parameters offered by the following regular screens.
• PLAY mode, PROGRAM function: Program selection, program name. ( 110)
• PLAY mode, SAMPLE function: Sample selection, sample name. ( 112)
EFFECT SETUP CONTROL
FILTER EG LFO MIDI / CTRL
METER EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
You use this screen to select a program or sample for playback or editing; to change the
name of a sample or program; to enable or disable the "sample solo" feature, and to
enable or disable the "MIDI to sample" feature. All of these operations are described on
the next page.
Program & Sample Selection Screen
Push Knob 1.
Knob 3 Knob 4
- -
Chapter 4
Knob 5
-
PLAY Mode
95