Trim/Loop Function; Trim/Loop - Config (Configure) - Yamaha A3000 Owner's Manual

TRIM/LOOP Function

This section describes the EDIT mode's TRIM/LOOP function. You use this function to
change the playback area on the waveform (the playback "start" and "end" points), to
trim off extraneous waveform data, to set the playback direction (forward or backward)
and loop characteristics (loop range and type), and to make various other related set-
tings.
FYI
Keep in mind that the COMMAND key gives you rapid access to a number of helpful
commands while you are working with this function. For example, you can use the
COMMAND key when you want to save your edit results to disk, or when you want to
cancel your new changes and restore the previously saved data. ( 147)

TRIM/LOOP - Config (Configure)

Selects TRIM/LOOP editing options.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Use this page to select TRIM/LOOP edit options. You can choose to lock the waveform
playback and loop lengths, or you can enable automatic zeroing or automatic snap (see
below). You can also select the type of value used to indicate the sample's end and loop-
end addresses.
Important
The Length, Zero, and Snap options are mutually exclusive: enabling any one of these
automatically disables the other two.
Knob 1 Change Page
• Turn the knob to change to a different page within the TRIM/LOOP function. Avail-
• Push the knob to move to the Program/Sample Selection screen. ( 95)
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
able pages are: Config (this page), Wave, Loop, and WvMode.
TRIM/LOOP Function
Turn Knob 1 to select Config.
Knob 3 Knob 4
- --
Select P/S
Chapter 5
Knob 5
EDIT Mode
161