COMMAND Pages
SETINIT (Register Initial Parameter Values)
Registers current parameter values as "initial" values.
PLAY
PROGRAM
EDIT
TRIM / LOOP
REC
RECORD
DISK
PROGRAM
UTILITY
TOTAL EQ
Turn action
Push action
Knob 1
Chapter 5
EDIT Mode
160
SAMPLE
EASY EDIT
EFFECT
SETUP
MAP / OUT
FILTER
EG
LFO
SETUP
METER
EFFECT
EXT CTRL
SAMPLE
SEQUENCE
VOLUME
DISK
PANEL PLAY
SEQUENCE
MASTER
SYSTEM
Knob 1
This command registers the selected sample's parameter settings (filter settings, LFO
settings, EG settings, and so on) as the default values to be used for new samples. If the
current sample is set to use a HiPass1 filter, for example, then any subsequent sample
that you record will also be initially set to use a HiPass1 filter.
Important
This command does not operate on sample banks.
FYI
The initial settings are stored in nonvolatile memory, and are not lost at power-off.
Change Page
• Turn the knob to change to a different command page.
• Push the knob to register the new initial values. The A3000 returns a confirmation
screen. Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
CONTROL
MIDI / CTRL
Press the COMMAND key, then turn Knob 1 to select >SETINIT.
MONITOR
IMPORT
MIDI
Knob 2
Knob 3
-
-
-
-
Knob 4
Knob 5
-
-
-
-
>SETINIT