Eg - Aegmode (Aeg Mode Settings) - Yamaha A3000 Owner's Manual

EG Function

EG - AEGMode (AEG Mode Settings)

Sets up the AEG's scaling, velocity sensitivity, and attack type.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Knob 3
Chapter 5 EDIT Mode
190
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
Use this page to determine how AEG rates vary with velocity and keyboard location, and
to select the AEG attack type (rising or flat).
Change Page
• Turn the knob to change to a different page within the EG function. Available pages
are: AEG, AEGMode (this page), FEGRate, FEGLevel, FEGMode, PEGRate, PEGLevel,
and PEGMode.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
RateScl
This setting determines how the AEG rates (attack, decay, and release rates) vary ac-
cording to keyboard location (pitch) of the played note. Set the value to 0 to keep rates
the same for all keyboard notes. Positive settings cause rates to increase as you move up
the keyboard, while negative settings cause rates to decrease as you move up the key-
board.
Vel Rate
This value sets the AEG's velocity sensitivity: the amount by which the AEG rates (at-
tack, decay, and release rates) vary in response to the velocity (force) of the played note.
Set the value to 0 to keep rates the same for all velocities. Positive settings cause rates to
increase as velocity increases, while negative settings cause rates to decrease as velocity
increases.
CONTROL
MIDI / CTRL
Turn Knob 1 to select AEGMode.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= -7,...,+7
= -63,...,+63
Knob 4 Knob 5
-
- -
Select P/S