Yamaha A3000 Owner's Manual page 269

Knob 1
Push the knob to move to the Program/Sample Selection screen. ( 95)
Volume
Knobs 2, 3
• Turn either knob to select the volume containing the objects (samples, programs, or
sequences) that you want to load into the main memory. Whenever you execute a
load, the A3000 always takes the data from the volume you select here. In most cases
you will also use this volume as the destination for your data saves (although you are
free to select a different volume when making the save).
Note that you can only select volumes that are located on the currently selected disk
(partition). To change to a different disk, use the DISK function. ( 268)
• Push either knob if you want to change the name of the selected volume. The A3000
then displays the name-editing screen. For information about how to edit name strings,
see "Entering Names" ( 88). Note that it is not possible to change the name of
volumes on floppy disks.
Knob 4
Push this knob if you want to load all objects (programs, samples, and sequences) from
the selected volume into the A3000 main memory. The A3000 returns a confirmation
screen. Press Knob 5 (>YES) to execute the load, or Knob 4 (>NO) to cancel.
Knob 5
• Push the knob to add a new, empty volume to the selected disk (partition). The A3000
automatically names the volume New Volume. (If a volume with this name already
exists, the A3000 appends a sequential number to the new name.) You can then change
the name by pressing Knob 2 or 3.
• Note that you cannot add a volume to a floppy disk.
= volume name
VOLUME Function
Select P/S
Edit the Name
>LOAD
>NEW
Chapter 7 DISK Mode
267