Setup - Keyrnge - Yamaha A3000 Owner's Manual

SETUP Function

SETUP - KeyRnge

Sets the key range and "original key" for the new sample(s).
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Chapter 6 RECORDING Mode
232
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
You use this page to set the key range and "original key" settings for the sample(s) that
you are about to record.
Note that you cannot set these values if the Target page ( 230) is set up in either of the
following ways.
• If the Sample parameter is set to Replace. In this case, the existing sample's settings
are automatically retained.
• If the Sample parameter is set to New+ and the ToPgm parameter is set to
C1 ,...,C5 .
FYI
You can use the Note setting in the UTILITY | SYSTEM Display page ( 302) to select
whether key values are shown by name ("C-2" to "G8") or by the corresponding MIDI
note number (0 to 127). Descriptions below assume that you are using name display.
Change Page
• Turn the knob to change to a different page within the SETUP function. Available
pages are: RecData, Target, KeyRnge (this page), Trigger, and Process.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
OrigKey
• Turn the knob to set the sample's "original key" — the key that best represents the
sample's inherent pitch.
• Push the knob if you want to set the value using MIDI input. Be sure that the knob
indicator is blinking, then transmit the note from your MIDI device. Then lock the
value in by pushing the same knob again or by changing to a different screen.
CONTROL
MIDI / CTRL
Turn Knob 1 to select KeyRnge.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
= C-2,...,G8
Knob 4 Knob 5
-
-
Select P/S
MIDI IN