Filter - Fltsens (Filter Sensitivity) - Yamaha A3000 Owner's Manual

FILTER Function

FILTER - FltSens (Filter Sensitivity)

Selects the filter's velocity sensitivity.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knobs 2, 3
Knobs 4, 5
Chapter 5 EDIT Mode
184
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
This page determines how velocity affects the filter's cutoff frequency and Q/Width value.
Change Page
• Turn the knob to change to a different page within the FILTER function. Available
pages are: Filter, FltSens (this page), FltScale, and EQ.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Vel Cutoff
Determines how the cutoff frequency changes in response to velocity. If you set the
value to 0, the cutoff frequency remains the same at all velocities. Positive values cause
the cutoff frequency to move up as velocity increases, while negative values cause the
frequency to move down as velocity increases.
Vel Q/Width
Determines how the Q/width value changes in response to velocity. If you set the value
to 0, the Q/width value remains the same at all velocities. Positive values cause the value
to increase as velocity increases, while negative values cause the value to decrease as
velocity increases.
CONTROL
MIDI / CTRL
Turn Knob 1 to select FltSens.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= -63,...,+63
= -63,...,+63
Knob 4 Knob 5
- -
Select P/S