Trim/Loop - Wvmode (Set Wave Mode) - Yamaha A3000 Owner's Manual

TRIM/LOOP Function

TRIM/LOOP - WvMode (Set Wave Mode)

Sets the loop mode and the start-address velocity sensitivity.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Knob 3
Chapter 5 EDIT Mode
168
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
• Use this page to select the loop mode and the start-address velocity sensitivity.
• The right side of the screen indicates the selected sample's sampling rate.
Change Page
• Turn the knob to change to a different page within the TRIM/LOOP function. Avail-
able pages are: Config, Wave, Loop, and WvMode (this page).
• Push the knob to move to the Program/Sample Selection screen. ( 95)
LpMode
• Sets the loop mode. (Note the you can also use this setting to cause the sample to
play back in reverse.)
• The six loop modes are illustrated and described on the next page.
Vel Start
This value sets the start-address velocity sensitivity: the degree by which the start point
varies in response to the velocity (force) of the played note. This feature gives you added
control over the attack part of the playback.
A value of 0 leaves the start address constant for all velocities. Positive values cause the
start-point to move forward (the address to get higher) at higher velocities, and to move
backward at lower velocities. Negative settings have the opposite effect.
CONTROL
MIDI / CTRL
Turn Knob 1 to select WvMode.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= Select from 6 types.
= -63,...,+63
Knob 4 Knob 5
- -
- -
Select P/S