Eg - Fegmode (Feg Mode Settings) - Yamaha A3000 Owner's Manual

EG Function

EG - FEGMode (FEG Mode Settings)

Sets up the FEG's scaling and velocity sensitivities.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Knob 3
Chapter 5 EDIT Mode
196
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
Use this page to determine how FEG rates vary with keyboard location and velocity, and
how FEG levels vary with velocity.
Change Page
• Turn the knob to change to a different page within the EG function. Available pages
are: AEG, AEGMode, FEGRate, FEGLevel, FEGMode (this page), PEGRate, PEGLevel,
and PEGMode.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
RateScl
This setting determines how the FEG rates (attack, decay, and release rates) vary ac-
cording to keyboard location (pitch) of the played note.
Set the value to 0 to keep rates the same for all keyboard notes. Positive settings cause
rates to increase as you move up the keyboard, while negative settings cause rates to
decrease as you move up the keyboard.
Vel Rate
This value sets the velocity sensitivity of the FEG rates: the amount by which the FEG
rates (attack, decay, and release rates) vary in response to the velocity (force) of the
played note.
Set the value to 0 to keep rates the same for all velocities. Positive settings cause rates to
increase as velocity increases, while negative settings cause rates to decrease as velocity
increases.
CONTROL
MIDI / CTRL
Turn Knob 1 to select FEGMode.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= -7,...,+7
= -63,...,+63
Knob 4 Knob 5
- -
Select P/S