Checking The Lean Angle Sensor; Checking The Starter Motor Operation - Yamaha 2009 Diversion XJ6S Service Manual

b. Measure the crankshaft position sensor re-
sistance.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
EAS28130

CHECKING THE LEAN ANGLE SENSOR

1. Remove:
Lean angle sensor
G
2. Check:
Lean angle sensor output voltage
G
Out of specification → Replace.
Lean angle sensor output voltage
Less than 65° ° ° ° : 0.4–1.4 V
More than 65° ° ° ° : 3.7–4.4 V
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Connect the lean angle sensor coupler to the
wire harness.
b. Connect the digital circuit tester (DC 20 V) to
the lean angle sensor coupler as shown.
Digital circuit tester
90890-03174
Model 88 Multimeter with tachom-
eter
YU-A1927
Positive tester probe →
G
Yellow/Green "1"
Negative tester probe →
G
Black/Blue "2"
2 1
8-162
ELECTRICAL COMPONENTS
65 ˚
65 ˚
c. Set the main switch to "ON".
d. Turn the lean angle sensor 65°.
e. Measure the lean angle sensor output volt-
age.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
EAS28940
CHECKING THE STARTER MOTOR
OPERATION
1. Check:
Starter motor operation
G
Does not operate → Perform the electric
starting system troubleshooting, starting with
step 4.
Refer to "TROUBLESHOOTING" on page
8-13.
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Connect the positive battery terminal "1" and
starter motor lead "2" with a jumper lead "3".
EWA13810
WARNING
A wire that is used as a jumper lead must
G
have at least the same capacity of the bat-
tery, otherwise the jumper lead may burn.
This check is likely to produce sparks,
G
therefore, make sure no flammable gas or
fluid is in the vicinity.
b. Check the starter motor operation.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
L /G B /L
1 2