Changing The Engine Oil - Yamaha 2009 Diversion XJ6S Service Manual

3. Check:
Engine oil level
G
The engine oil level should be between the
minimum level mark "a" and maximum level
mark "b".
Below the minimum level mark → Add the
recommended engine oil to the proper level.
Type
SAE 10W-30, SAE 10W-40, SAE
15W-40, SAE 20W-40 or SAE
20W-50
Recommended engine oil grade
API service SG type or higher,
JASO standard MA
-20 -10 0 10 20 30 40 50 ˚C
SAE 10W-30
SAE 10W-40
SAE 10W-50
SAE 15W-40
ECA4S81007
NOTICE
Engine oil also lubricates the clutch and
G
the wrong oil types or additives could
cause clutch slippage. Therefore, do not
add any chemical additives or use engine
oils with a grade of CD "a" or higher and do
not use oils labeled "ENERGY CONSERV-
ING II" "b" or higher.
Do not allow foreign materials to enter the
G
crankcase.
SAE 20W-40
SAE 20W-50
PERIODIC MAINTENANCE
TIP
Before checking the engine oil level, wait a few
minutes until the oil has settled.
4. Start the engine, warm it up for several min-
utes, and then turn it off.
5. Check the engine oil level again.
TIP
Before checking the engine oil level, wait a few
minutes until the oil has settled.
EAS20790

CHANGING THE ENGINE OIL

1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
Bottom cowling
G
Refer to "GENERAL CHASSIS" on page 4-1.
Engine oil filler cap "1"
G
Engine oil drain bolt "2"
G
(along with the gasket)
2
3-24
1