Table of Contents
Advertisement
10.Install:
Radiator cap
G
Radiator cap lock bolt
G
Radiator cap lock bolt
5 Nm (0.5 m·kgf, 7.2 ft·lbf)
Right side cowling
G
Refer to "GENERAL CHASSIS" on page 4-1.
11.Fill:
Coolant reservoir
G
(with the recommended coolant to the maxi-
mum level mark "a")
12.Install:
Coolant reservoir cap
G
13.Start the engine, warm it up for several min-
utes, and then stop it.
14.Check:
Coolant level
G
Refer to "CHECKING THE COOLANT LEV-
EL" on page 3-26.
TIP
Before checking the coolant level, wait a few
minutes until the coolant has settled.
EAS20S13003
CHECKING THE FRONT AND REAR BRAKE
SWITCH
Refer to "CHECKING THE SWITCHES" on
page 8-149.
EAS21330
ADJUSTING THE REAR BRAKE LIGHT
SWITCH
TIP
The rear brake light switch is operated by move-
ment of the brake pedal. The rear brake light
switch is properly adjusted when the brake light
comes on just before the braking effect starts.
1. Check:
Rear brake light operation timing
G
Incorrect → Adjust.
2. Adjust:
Rear brake light operation timing
G
PERIODIC MAINTENANCE
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Hold the main body "1" of the rear brake light
switch so that it does not rotate and turn the
adjusting nut "2" in direction "a" or "b" until the
rear brake light comes on at the proper time.
Direction "a"
Brake light comes on sooner.
Direction "b"
Brake light comes on later.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
EAS21690
CHECKING AND LUBRICATING THE
CABLES
The following procedure applies to all of the in-
ner and outer cables.
EWA13270
WARNING
Damaged outer cable may cause the cable to
corrode and interfere with its movement. Re-
place damaged outer cable and inner cables
as soon as possible.
1. Check:
Outer cable
G
Damage → Replace.
2. Check:
Cable operation
G
Rough movement → Lubricate.
Recommended lubricant
Engine oil or a suitable cable lu-
bricant
TIP
Hold the cable end upright and pour a few drops
of lubricant into the cable sheath or use a suit-
able lubricating device.
3-29
2
Advertisement
Chapters
Table of Contents
Troubleshooting
