Removing The Quick Fastener - Yamaha 2009 Diversion XJ6S Service Manual

TIP
If the pin "1" on the terminal is flattened, bend it
up.
TIP
If the contact seems not good, pull the terminal
by hand and check its condition.
4. Connect:
Lead
G
Coupler
G
Connector
G
TIP
Make sure all connections are tight.
5. Check:
Continuity
G
(with the pocket tester)
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
TIP
If there is no continuity, clean the terminals.
G
When checking the wire harness, perform
G
steps (1) to (3).
As a quick remedy, use a contact revitalizer
G
available at most part stores.
CHECKING THE CONNECTIONS
TIP
When you check the voltage or electrical conti-
nuity, insert the measuring probe from back side
as you can insert from back side.
1
1. Probe
2. Coupler
EAS21840

REMOVING THE QUICK FASTENER

TIP
To remove the quick fastener, push its center
with a screwdriver, then pull the fastener out.
1-27
2