Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel - Yamaha 2009 Diversion XJ6S Service Manual

6. Install:
Rear wheel sensor lead holder "3"
G
Clamp "4"
G
Rear wheel sensor lead holder
bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
4
7. Connect:
Rear wheel sensor coupler "5"
G
a
4
3
ECA14500
NOTICE
To route the rear wheel sensor lead, refer to
"CABLE ROUTING" on page 2-43.
8. Check:
Rear wheel sensor installation
G
Check if the wheel sensor housing is installed
properly.
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
After replacing the tire, wheel or both, the rear
G
wheel static balance should be adjusted.
Adjust the rear wheel static balance with the
G
brake disc and rear wheel drive hub installed.
1. Adjust:
Rear wheel static balance
G
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-12.
EAS22160

INSTALLING THE REAR WHEEL

1. Lubricate:
Wheel axle
G
Wheel bearings
G
Oil seal lips
G
Recommended lubricant
Lithium-soap-based grease
2. Install:
Collar
G
Rear brake caliper assembly
G
Rear wheel
G
Indicator plate
G
Washer
G
Rear wheel axle
G
3. Adjust:
Drive chain slack
G
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" on page 3-18.
4-21
REAR WHEEL
5