Maintenance Of The Rear Wheel Sensor And Sensor Rotor - Yamaha 2009 Diversion XJ6S Service Manual

2. Replace:
Rear wheel sprocket
G
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
a. Remove the self-locking nuts and the rear
wheel sprocket.
b. Clean the rear wheel drive hub with a clean
cloth, especially the surfaces that contact the
sprocket.
c. Install the new rear wheel sprocket.
Rear wheel sprocket self-locking
nut
80 Nm (8.0 m·kgf, 57 ft·lbf)
TIP
Tighten the self-locking nuts in stages and in a
crisscross pattern.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
EAS22200
MAINTENANCE OF THE REAR WHEEL
SENSOR AND SENSOR ROTOR
ECA4B56008
NOTICE
Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the rear wheel hub "1", otherwise the
wheel sensor rotor equipped in the wheel
hub may be damaged, resulting in improper
performance of the ABS system.
1
ECA4S81012
NOTICE
Be sure not to contact the sensor electrode
G
to any metal part when removing the rear
wheel sensor from the sensor housing.
Do not operate the brake lever when re-
G
moving the brake caliper.
Removing the rear wheel sensor
1. Disconnect:
Rear wheel sensor coupler "1"
G
2. Remove:
Clamp "2"
G
Rear wheel sensor lead holder "3"
G
3. Remove:
Rear wheel sensor "4"
G
4
4. Remove:
Rear wheel
G
Refer to "REMOVING THE REAR WHEEL"
on page 4-18.
5. Remove:
Sensor rotor "5"
G
4-19
REAR WHEEL
2
2
3
1