Ip Status - Cisco TelePresence Administrator's Manual

Overview and status information

IP status

The IP status page (Status > System >
The following information is displayed:
Field Description
IP section:
Protocol Indicates the IP protocol supported by the VCS:
IPv4: it only accepts registrations from endpoints using an IPv4 address, and only takes calls
n
between two endpoints communicating via IPv4. It communicates with other systems via IPv4
only.
IPv6: it only accepts registrations from endpoints using an IPv6 address, and only takes calls
n
between two endpoints communicating via IPv6. It communicates with other systems via IPv6
only.
Both: it accepts registrations from endpoints using either an IPv4 or IPv6 address, and takes calls
n
using either protocol. If a call is between an IPv4-only and an IPv6-only endpoint, the VCS acts
as an IPv4 to IPv6 gateway. It communicates with other systems via either protocol.
IPv4 The IPv4 gateway used by VCS.
gateway
IPv6 The IPv6 gateway used by VCS.
gateway
Advanced Indicates whether the second LAN port has been enabled. This is done by installing the Advanced
Networking Networking option key.
LAN 1 Shows the IPv4 address and subnet mask, and IPv6 address of the LAN 1 port.
LAN 2 If the Advanced Networking option key has been installed, this shows the IPv4 address and subnet
mask, and IPv6 address of the LAN 2 port.
DNS section:
Server 1..5 The IP addresses of each of the DNS servers that are queried when resolving domain names. Up to
address 5 DNS servers may be configured.
Domain Specifies the name to be appended to the host name before a query to the DNS server is executed.
The IP settings can be configured via the
Cisco VCS Administrator Guide (X8.1.1)
IP) shows the current IP settings of the VCS.
IP page.
IP status
Page 325 of 507