Network Operations; Initialization - Honeywell IP Receiver User Manual

5 Network Operations

Initialization

If IP Receiver is to be connected to a router, you must assign a static IP address that is not
occupied by other device for IP Receiver, and you can assign at most 2 IP addresses. After
performing the system configuration (see
addresses for IP Receiver by following these steps:
1. Access the login page of IP Receiver System by entering
http://192.168.1.2
2. Log in IP Receiver System. For more information, see
3. On the "Configuration" page, specify an unoccupied IP address in the field of
"IP_address1" for gigabit Ethernet port 1, and specify a second unoccupied
address in the field of "IP_address2" for gigabit Ethernet port 2. Click Run to save
the configuration.
The following figure shows the configuration page of IP Receiver (see
Configuration
"IP_address1" corresponds to the IP of gigabit Ethernet port 1, while
Note
"IP_address2" corresponds to the IP of gigabit Ethernet port 2. Do not
mix the two addresses during configuration.
System Configuration
in IE (see Figure 5-2
on page 29 for more information).
Figure 5-1 Initial Configuration of IP Receiver
on page 23), configure the IP
http://192.168.0.2
on page 28 for the login page).
Login
Honeywell
or
on page 28.
27