Table 2-3 Sw5 Protocol Settings - Honeywell ACUIX User Manual

Installing the Scan Assembly
Setting the Protocol (SW5)
Protocol Name
IntelliBus™
MAXPRO-mode (default)
VCL - RS485
VCL UTC
("Up-the-Coax")
Diamond
Pelco P
Pelco D
Pelco P_AD
Pelco D_AD
6
The ACUIX PTZ dome supports the following protocols for communicating with
other devices:
• IntelliBus™
• MAXPRO-mode
• VCL
• Diamond
• Pelco P, Pelco D, Pelco P_AD, Pelco D_AD
Select a protocol that is compatible with the controller or other device that you
want to connect to.
The protocol is set using DIP switch SW5 on the circuit board (see
The factory default is MAXPRO-mode (a mode of using Diamond protocol which
has special presets for functions beyond pan, tilt, zoom, focus, and preset).
Table 2-3 SW5 Protocol Settings
Switch Position
1 2
OFF
OFF ON
ON ON
OFF OFF
ON OFF
ON OFF
OFF ON
ON OFF
OFF ON
To set the protocol:
• Using Table 2-3 as a reference, position the pins on switch SW5 to
correspond to the protocol that you have selected.
Note Normally, pin 8 should be set to the ON position. Setting the switch to
OFF allows the address, protocol, baud rate, and parity settings to be
changed from the OSD, which is not recommended for most
installations.
3 4
OFF OFF OFF
OFF OFF
OFF OFF
ON OFF
OFF OFF
ON OFF
ON OFF
ON OFF
ON OFF
Table
5 6 7
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
ON OFF OFF
2-3).
8
ON
ON
ON
ON
ON
ON
ON
ON
ON