Setting Exposure; Table 7-1 Auto Exposure Control Mode Settings - Honeywell ACUIX User Manual

Setting Exposure

Document 800-05662V1 Rev A
04/11
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Auto Exposure (AE)
You can toggle auto exposure on or off by using special preset 92 when the
dome is configured for MAXPRO-mode/VCL/VCL UTC/Pelco P/Pelco D protocol.
To enable/disable auto exposure:
1. Exit the OSD menus until you have manual control of the dome.
2. Enter preset 92 on your controller to toggle auto exposure on (default) or
off.
Setting the Auto Exposure (AE) Mode
You can set the auto exposure to Auto AE mode or to Manual AE mode. You can
also slow the AE response speed to minimize exposure changes caused by
momentary bright spots in the image.
To set the Auto AE mode:
1. Ensure that auto exposure is enabled (preset 92).
2. Enter preset 90 on your controller to return to bring up the OSD main menu.
3. Select 5 Camera Options
4. Select the desired setting using
associated with each exposure mode are displayed below the menu
options.
Table 7-1 Auto Exposure Control Mode Settings
Setting
Auto AE Mode
Auto AER1 Mode
Auto AER2 Mode
Auto AE+ Mode
Auto AER+1 Mode (default)
Auto AER+2 Mode
Auto AER+3 Mode

2 Exposure Control
Table 7-1 as a reference. The features
NightShot Auto
Control NightShot
Sensitivity
MAN NA
AUTO HIGH
AUTO MID
MAN NA
AUTO HIGH
AUTO MID
AUTO LOW

1 Auto AE Mode.
Digital Slow
Shutter
OFF
OFF
OFF
AUTO
AUTO
AUTO
AUTO
41