Preparing To Configure The Dome; Pre-Configuration Checklist - Honeywell ACUIX User Manual

Preparing to Configure the Dome

Pre-Configuration Checklist

Document 800-05662V1 Rev A
04/11
This chapter contains the following sections:
• Pre-Configuration Checklist, page
• Accessing the Main
• Navigating OSD Menus, page
• Sending the Dome to a
• Special Presets, page
• OSD Menu Tree, page
After you have installed the PTZ dome, you are ready to begin configuring the
dome settings from the OSD menu. To do this, you will need a keyboard
controller and a monitor.
The ACUIX High-Speed PTZ Dome is compatible with all Honeywell controllers,
including the UltraKey Touch, UltraKey Lite, UltraKey Plus, HJZTP, HKJMMTP,
and HEGS5300. It is also compatible with third-party controllers using Pelco P or
Pelco D control protocols.
Before you begin configuring the dome, do the following:
1. Make sure the dome is assigned to the controller you are using. The dome
address (for example, CAM 001) should appear on the controller LCD
display.
2. Turn on the dome.
3. Confirm that video is displaying on the monitor. A startup screen should
appear showing the protocol, baud rate, parity, data bits, camera type, and
firmware version of the dome.
4. If the dome does not "find home" automatically, enter a control command
(such as moving the joystick left or right). The message
appears, followed by
11
Menu, page 12
13
Preset, page 13
14
15
Home Found
.
3
Finding Home...
11